Page 230 - Manual_Polaris_RZR_ProXP-20-21

ENGINE / COOLING SYSTEM

7. Apply a thin, continuous film of Crankcase Sealant 11. Install the eight M10 y, two M8 u and one M6 i
(PN 2871557) to upper crankcase mating surface as lower crankcase bolts. Tighten all bolts lightly by
shown. Do not allow sealant to dry before assembly. hand.

NOTICE NOTICE
Install new M10 lower crankcase bolts.
DO NOT block oil passages t with crankcase sealant.

12.Torque lower crankcase bolts in sequence to
8. Carefully place lower crankcase on upper case, specification. Repeat sequence to verify final torque.
making sure the oil pump drive chain is fed through
the lower crankcase.

TORQUE
9. Tap lower crankcase with a rubber hammer to seat Lower Crankcase Bolts:
the case halves together. M10 Bolts:
10.Inspect crankcase mating surfaces to be sure they Step 1: 9 ft-lb (12 Nm)
are joined properly. Investigate the cause of any Step 2: 21 ft-lb (28 Nm)
gaps.
Step 3: Tighten add’n 90°
M8 Bolts:
26 ft-lb (35 Nm)

M6 Bolts:
9 ft-lb (12 Nm)

13.Rotate the engine so the cylinder is facing up.

3.86 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.