Page 233 - Manual_Polaris_RZR_ProXP-20-21

ENGINE / COOLING SYSTEM

28.Proceed to Flywheel Installation page 3.89 and then 4. Reassemble starter one-way clutch and gear using
Cylinder Head Installation page . the following illustration.

STARTER ONE-WAY CLUTCH
ASSEMBLY
1. Install one-way clutch in clutch hub with flange of
clutch q engaged in recess.

3

w Torque Limit Gear y Flywheel
Pin
e Starter Gear u One-Way Clutch Asm

r Screws i Torque Limit Gear
Asm
2. Clean screw threads in flywheel to remove all oil or
grease. t Bolt
3. Place one-way clutch on flywheel and install the three 5. If starter gear was replaced, inspect the torque limit
screws. Torque screws to specification.
gear.
TORQUE 6. After assembly, be sure the starter gear rotates in the
One-Way Clutch Retaining Screws: clockwise direction only.
9 ft-lb (12 Nm)

FLYWHEEL INSTALLATION

1. If previously removed, reinstall the flywheel key.
2. Inspect and clean crankshaft and flywheel taper with
isopropyl alcohol or similar cleaning solution.
Replace crankshaft if surface damage is present.
Clean taper of crankshaft to remove all oil or grease.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 3.89
© Copyright Polaris Industries Inc.