Page 328 - Manual_Polaris_RZR_ProXP-20-21

PVT SYSTEM

8. Install PVT intake hose, and torque hose clamp t to 5. Remove the Driven Clutch Bolt and washer.
specification.

6. Add shims q to move the belt closer to the inner
TORQUE sheave of the drive clutch, or remove shims to move
the belt closer to the outer sheave of the drive clutch.
PVT Intake Hose Clamp:
25 in-lbs (3 Nm) IMPORTANT
Ensure the driven clutch splines and transmission
splines and shaft are clean and free of debris.

DRIVEN CLUTCH ALIGNMENT
7. Reinstall the washers and Driven Clutch Bolt. Torque
Most vehicles require four to six alignment washers (PN to specification.
7557060) for proper alignment. As many as eight
alignment washers or as few as zero may be used. TORQUE
Driven Clutch Bolt:
IMPORTANT
43 ft-lbs (58 Nm)
The main washer directly under the head of the bolt
must always be used.
NOTICE
When finished, the driven clutch should not rotate on its
1. Remove the outer clutch cover from the vehicle.
own, or should stop with minimal drag when using a
2. Rotate the driven clutch clockwise several times new bearing.
before inspection.

3. Inspect where the belt is riding on the drive clutch.
NOTICE
A mobile device can be used to capture a picture of the
belt tracking to determine if adjustment is needed.

4. Remove the drive belt.

6.38 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.