Page 342 - Manual_Polaris_RZR_ProXP-20-21

TRANSMISSION

SHIFT CABLE ADJUSTMENT 6. Once the proper adjustment is obtained, place the
shift cable and upper jam nut into the mount. Tighten
1. Locate the shift cable attached to the transmission the lower jam nut against the mount.
case in the right rear wheel well area.
2. Inspect shift cable q, clevis pin, pivot bushings, and TORQUE
dust boot w. Replace if worn or damaged. Shift Cable Jam Nuts:
16 ft-lb (22 Nm)

7. Start engine and shift through all gears to ensure the
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.

3. If adjustment is required, loosen the lower jam nut r
and pull the cable out of the mount e to move the
upper jam nut t.

4. Adjust the shift cable so there is the about the same
amount of cable travel when shifting slightly past
HIGH gear than when shifting to PARK.
5. Thread the upper or lower jam nut as required to
obtain proper cable adjustment.
NOTICE
This procedure may require a few attempts to obtain
the proper adjustment.

7.4 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.