Page 368 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

7. Install the rear brake caliper assembly and new bolts 10.Torque wheel hub nut to specification and install a
t. Torque to specification. new cotter pin i. Tighten nut slightly if necessary to
align cotter pin holes.

TORQUE
TORQUE
Rear Caliper Mounting Bolts:
33 ft-lbs (45 Nm) Hub Castle Nut:
180 ft-lbs (244 Nm)

8. Install lower radius rod. Torque fastener to
specification. 11. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
TORQUE
Outer Radius Rod Fastener:
52 ft-lbs (70 Nm) + 90° Wheel Nuts:
120 ft-lbs (163 Nm)
9. Install rear brake line guide u and two fasteners y.
Torque fasteners to specification. 12.Allow 4 hours for Loctite® 680 to cure before vehicle
use.

CAUTION
Loctite® MUSTcure for at least 4 hours before using
the vehicle.

13.Rotate wheel and check for smooth operation. Bend
both ends of cotter pin around end of spindle in
different directions.

TORQUE
Brake Line Guide Fasteners:
7 ft-lbs (10 Nm)

8.10 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.