Page 370 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

FRONT DRIVE SHAFT INSTALLATION 6. Install front wheel hub assembly r, new cone
washer t, and hand tighten the new castle nut.
1. Install new spring ring q on drive shaft. Apply an Install washer with domed side out.
anti-seize compound to the splines w.

7. Torque wheel hub nut y to specification and install a
2. Align splines of drive shaft with front gearcase and new cotter pin u. Tighten nut slightly if necessary to
reinstall the drive shaft.
align cotter pin holes. Bend both ends of cotter pin
3. Install drive shaft into the front bearing carrier. around end of spindle in different directions.

4. Install the upper and lower ball joint ends into the
front bearing carrier.
5. Install new pinch bolts and nuts e. Torque to
specification.

TORQUE
Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)

TORQUE 8. Install new brake caliper mounting bolts and torque to
Ball Joint Fasteners: specification.
44 ft-lbs (60 Nm) TORQUE
Front Caliper Mounting Bolts:
33 ft-lbs (45 Nm)

CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.

8.12 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.