Page 418 - Manual_Polaris_RZR_ProXP-20-21
P. 418

STEERING / SUSPENSION


                4. Install the steering wheel hub and retaining nut.  STEERING SHAFT BUSHING
                   Torque the nut to specification.                  REPLACEMENT
                                     TORQUE                                                NOTICE
                                Steering Wheel Nut:                     Replacement steering column assembly comes with
                                 65 ft-lbs (88 Nm)                       new upper and lower bearings installed. Use this
                                                                             procedure if replacing only the bushing.

                5. Be sure the front wheels are pointing straight ahead
                   and install the steering wheel and six fasteners.  1. Perform the “Steering Shaft Removal” procedure.
                   Torque fasteners to specification.
                                                                     2. Remove the steering wheel cover.
                                     TORQUE
                                                                     3. Remove steering shaft retaining nut.
                             Steering Wheel Fasteners:
                                                                     4. Press steering shaft out of the steering column.
                                 72 in-lbs (9 Nm)

                6. Install a new upper steering shaft pinch bolt and nut.
                   Torque pinch bolt to specification.

                                     TORQUE
                              Steering Shaft Pinch Bolt:
                                  25 ft-lb (34 Nm)


                7. Reconnect both electrical harnesses onto the power
                   steering unit. Be sure the connectors snap into place.
                8. Reinstall the black plastic cover over the power
                   steering unit and install the two Torx fasteners.
                9. Vehicles equipped with Dynamix suspension having a
                   steering shaft, EPS unit, steering rack, or tie rod   q Steering Wheel        r Bushing
                   removed/adjusted/disconnected MUST have Steering      Cover
                   Angle Sensor Centering procedure performed once
                   everything is reinstalled. Refer to Steering Angle    w Nut                   t Steering Column
                   Sensor Centering (Dynamix) page 12.18.
                                                                         e Steering Wheel        y Steering Shaft
                10.Turn the key switch on and test EPS operation.

                                                                                           NOTICE
                                                                        Observe the order and location of the washers and
                                                                         spacers between the steering wheel and steering
                                                                                           column.


                                                                     5. Reinstall the upper washers and spacers in the order
                                                                        in which they were removed.
                                                                     6. Install the hub adapter and hand tighten the nut.

                                                                     7. Reinstall the steering shaft assembly in the vehicle.
                                                                        Install the lower portion of the steering shaft onto the
                                                                        power steering unit. Torque the lower pinch bolt to
                                                                        specification.
                                                                                          TORQUE
                                                                                   Steering Shaft Pinch Bolt:
                                                                                       25 ft-lb (34 Nm)







                9.14                                                       9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
                                                                                                © Copyright Polaris Industries Inc.
   413   414   415   416   417   418   419   420   421   422   423