Page 422 - Manual_Polaris_RZR_ProXP-20-21

STEERING / SUSPENSION

FRONT A-ARM REMOVAL / 5. Using a soft face hammer, tap on bearing carrier to
INSTALLATION loosen the upper A-arm ball joint end while lifting
upward on the upper A-arm. Completely remove the
REMOVAL ball joint end from the bearing carrier.
1. Elevate and safely support the front of the vehicle and 6. To gain access to the front A-arm fasteners, remove
remove the front wheel. four fasteners r and remove the front bumper cover.
2. Remove lower shock fastener q from upper A-arm.

7. Loosen and remove the upper A-arm front through-
3. Remove the fastener w retaining the front stabilizer bolts t. Remove the upper A-arm from the vehicle.
bar link to the upper control arm.

8. Drill out the rivets retaining brake line to the A-arm.
4. Remove upper ball joint pinch bolt e from bearing 9. Examine A-arm bushings and pivot tube. Replace if
carrier. worn. Discard hardware.

WARNING
The locking agent on the existing bolts was destroyed
during removal. DO NOT reuse old hardware. Serious
injury or death could result if fasteners come loose
during operation.

10.If not replacing the A-arm, thoroughly clean the A-arm
and pivot tube.
INSTALLATION
1. Install new ball joint into A-arm. Refer to “Ball Joint
Replacement” section.

9.18 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.