Page 338 - Manual Oficina XP 1000 14-16
P. 338
FINAL DRIVE
6. Inspect the roller surface on the inside of the ring FRONT GEARCASE REMOVAL
gear for gouging/rough spots. 1. Raise and support vehicle
2. Place gear selector in neutral.
3. Refer to FRONT DRIVE SHAFT, page and
remove both front drive shafts from the front
gearcase.
4. Remove the front section of the prop shaft (see
Chapter 7 – FRONT PROPSHAFT SERVICE,
page ).
5. Disconnect the wire harness for the front gearcase
and remove the harness from the retaining dart.
6. Remove the vent line from the front gearcase and
plug vent line fitting.
7. Remove the four bolts r securing the front gearcase
7. Inspect the roll cage o assembly for cracks or to the frame.
excessive wear. If damaged, replace the roll cage
assembly.
8. Inspect the rollersa for nicks and scratches. The
rollers must slide up, down, in and out freely within
the roll cage sliding surfaces and H-springs.
8. Rotate front of gearcase up so the input shaft is
facing down. Lift and remove the gearcase from the
front LH wheel well area and slide it out of the vehicle
above the upper A-arm.
7.36 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
