Page 341 - Manual Oficina XP 1000 14-16

FINAL DRIVE

10. Inspect the AWD coil located in the outer cover plate 13. Inspect clutch housing / ring gear (C) for a consistent
assembly. Refer to AWD Diagnosis, page 7.35 for wear pattern. Inspect the ring gear for chipped,
detailed inspection process. Replace the cover plate broken, or missing teeth.
seal and O-ring.
14. Inspect the roll cage assembly (B) sliding surfaces
and H-springs. The sliding surfaces must be clean
and free of nicks, burrs or scratches. If damaged,
replace the roll cage assembly.

11. Remove the roll cage assembly and rollers from the
clutch housing. Use a shop towel to cover the
housing in order to retain all the rollers.
NOTE 15. Inspect both output hub assemblies. Inspect the
bearings and replace if needed.
Rollers are spring loaded. Take care not to allow them
to fall out or lose them upon removal of the roll cage.
7
12. Thoroughly clean all parts and inspect the rollers (A)
for nicks and scratches. The rollers must slide up
and down and in and out freely within the roll cage
(B) sliding surfaces and H-springs.

16. Clean and inspect all remaining front gearcase
components. Check each for excessive wear or
damage.

NOTE
Refer to the “Electronic Parts Catalog” for individual
part availability. Most parts are to be replaced as an
assembly or as a complete kit.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 7.39
© Copyright Polaris Industries Inc.