Page 342 - Manual Oficina XP 1000 14-16

FINAL DRIVE

FRONT GEARCASE ASSEMBLY 5. Carefully install the rollers into the roll cage
1. As mentioned during gearcase disassembly section, assembly while installing the assembly into the
replace all O-rings, seals and worn components. clutch housing.
2. Install pinion shaft assembly and install internal snap NOTE
ring.
Install roll cage so that the ring gear grooves line up
NOTE with the roll cage windows (see below). Be sure role
cage top groove is facing upward.
If bearing replacement was required, press new bearing
onto the pinion shaft and install a new external snap
ring.

3. Install a new pinion shaft seal into the pinion gear
housing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.

6. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.

4. Install the RH output hub into the gearcase housing.

7.40 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.