Page 370 - Manual Oficina XP 1000 14-16
P. 370
STEERING / SUSPENSION
STABILIZER BAR REMOVAL STABILIZER BAR INSTALLATION
1. Lift and support vehicle by main frame. 1. Carefully install stabilizer bar through the LH wheel
well area.
2. Remove rear wheels nut and wheels.
NOTE
3. Identify / mark top side of the stabilizer bar to
reference during installation. Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.
4. Remove the fasteners retaining the stabilizer bar to
the linkage q on each side of the vehicle.
2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting (fittings are accessible through skid plate).
5. Install rear wheels and wheel nuts. Torque wheel
nuts to specification.
TORQUE
Rear Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
5. Remove the four fasteners w retaining the stabilizer Wheel Lug Nuts:
bar to the vehicle frame. 120 ft-lbs (163 Nm)
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel
well area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
8.22 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
