Page 368 - Manual Oficina XP 1000 14-16
P. 368
STEERING / SUSPENSION
TRAILING ARM SPHERICAL BEARING 5. Be sure to only press on outer most surface of
REPLACEMENT bearing race, do not press on the center spherical
bearing.
1. Remove trailing arm (see Chapter 8 – Trailing Arm
Removal / Installation, page 8.17).
2. Remove bushings and O-rings.
3. Remove snap ring q that retains the spherical
bearing.
6. Inspect trailing arm bearing housing for wear or
damage. Replace trailing arm if damaged.
7. Press in new bearing until fully seated into trailing
arm casting.
8. Install new snap ring, O-rings (not required) and
4. Properly support the trailing arm and press the bushings.
spherical bearing out of trailing arm casting.
8.20 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
