Page 366 - Manual Oficina XP 1000 14-16
P. 366
STEERING / SUSPENSION
4. Remove the lower radius rod mounting bolt r, nut 7. Remove the five remaining bolts y that attach the
and washer from the bearing carrier. Swing radius rear bearing carrier to trailing arm. Discard the nuts.
rod down. Discard the nut.
8. Remove the bearing carrier from the rear drive shaft
5. Remove the two brake caliper mounting bolts t. and trailing arm.
9. Rotate bearing by hand and check for smooth
CAUTION
rotation. Visually inspect bearing for moisture, dirt, or
Do not hang the caliper by the brake line. Use wire to corrosion. Replace bearing if moisture, dirt,
hang caliper to prevent damage to the brake line. corrosion, or roughness is evident (see Chapter 7 –
Rear Bearing Replacement, page 7.9).
6. Remove the rear wheel hub and brake disk 10. Remove the four fasteners u that secure the brake
assembly. line retainers to the trailing arm.
11. Remove the lower stabilizer bar linkage fastener.
Discard the nut.
12. Support trailing arm with suitable jack stand or
support.
8.18 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
