Page 365 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

REAR SUSPENSION

RADIUS ROD REMOVAL / INSTALLATION 8. Reverse this procedure to reinstall the radius rods.
The following procedure details upper and lower radius 9. Torque all fasteners to specification.
rod removal and replacement on one side of the vehicle.
Repeat the following steps to remove the A-arm from the NOTE
opposite side.
Use new attaching nuts upon installation of the rear
1. Raise and support vehicle by main frame. radius rods.

CAUTION
TORQUE
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service Radius Rod Mounting Bolts:
procedure. 40 ft-lb (54 Nm)

2. Remove the rear wheel nuts and rear wheel.
WARNING
3. Identify / mark radius rods “upper” and “lower”.
Upon radius rod installation, test vehicle at low speeds
4. Remove the nut, bolt and washer q & w attaching before putting into service.
the upper and lower radius rod to the bearing carrier.
Discard the nuts.
TRAILING ARM REMOVAL / INSTALLATION

NOTE
Use new attaching nuts upon installation of the rear
trailing arm and bearing carrier.

1. Raise and support vehicle by main frame.

CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. 8

2. Remove the four wheel nuts and remove the rear
5. Remove bolts e & r attaching radius rods to the
vehicle frame. Discard the nuts. wheel.
3. Remove the cotter pin q and loosen the rear wheel
hub castle nut w. Remove the nut, and two cone
washers e from the rear wheel hub assembly.

6. Remove radius rods from vehicle.
7. Examine radius rod shafts, boots and spherical
bearings. Replace entire radius rod if any excessive
wear is evident.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 8.17
© Copyright Polaris Industries Inc.