Page 58 - Manual Oficina XP 1000 14-16

MAINTENANCE

DRIVE SHAFT BOOT INSPECTION WHEEL AND HUB TORQUE TABLE
Inspect the front and rear drive shaft boots q for
damage, tears, wear or leaking grease. If the boots ITEM SPECIFICATION
exhibit any of these symptoms, they should be replaced. Wheel Nuts
Check to see the boot clamps w are properly positioned. (Cast Aluminum Wheels) 120 ft-lbs (163 Nm)
Refer to DRIVE SHAFT CV JOINT / BOOT
REPLACEMENT , page for drive shaft boot Hub Retaining Nuts
replacement. (Front and Rear) 110 ft-lbs (149 Nm)
Step 1: 24 in-lbs (3 Nm)
Beadlock Screws
Step 2: 7 ft-lbs (10 Nm)

NOTE
Do not lubricate the stud or the lug nut.

WHEEL REMOVAL
1. Position the vehicle on a level surface.
2. Place the transmission in PARK and stop the engine.
3. Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the wheel cap, cotter pin and
loosen the hub nut slightly.
4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5. Remove the wheel nuts and remove the wheel.

2.24 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.