Page 59 - Manual Oficina XP 1000 14-16

MAINTENANCE

WHEEL INSTALLATION TIRE INSPECTION
1. Verify the transmission is still in PARK. • Improper tire inflation may affect vehicle

2. Place the wheel in the correct position on the wheel maneuverability.
hub t. Be sure the valve stem w is toward the • When replacing a tire always use original equipment
outside and rotation arrows on the tire point toward size and type.
forward rotation. • The use of non-standard size or type tires may affect 2
vehicle handling.
3. Attach the wheel nuts q and finger tighten them.
4. Carefully lower the vehicle to the ground. WARNING
5. Torque the wheel nuts and/or hub nut e to the Operating with worn tires will increase the possibility of
proper torque specification. the vehicle skidding easily with possible loss of control.
Worn tires can cause an accident.
TORQUE Always replace tires when the usable tread depth has
Wheel Lug Nuts: worn out.
120 ft-lbs (163 Nm)

Hub Castle Nuts: TIRE PRESSURE
180 ft-lbs (244 Nm)
Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle’s
6. If hub nut was removed, install a new cotter pin r tool kit.
after the hub nut has been tightened. If the holes do
not line up, turn the hub nut counter-clockwise until CAUTION
the cotter pin can be installed.
Maintain proper tire pressure. Refer to the warning tire
pressure decal applied to the vehicle.

TIRE PRESSURE INSPECTION (COLD)

Model Front Rear
XP 16 psi (110 kPa) 16 psi (110 kPa)

XP4 19 psi (131 kPa) 21 psi (145 kPa)
High Lifter 18 psi (124 kPa) 18 psi (124 kPa)
Desert Edition 16 psi (110 kPa) 24 psi (165 kPa)

CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 2.25
© Copyright Polaris Industries Inc.