Page 63 - Manual Oficina XP 1000 14-16

MAINTENANCE

7. Remove the drain plug w and allow fluid to drain 2. Inspect shift cable, clevis pin, pivot bushings r, and
completely. dust boot e. Replace if worn or damaged.

2

8. Clean the drain plug magnetic surface. 3. If adjustment is required, loosen the lower jam nut y
and pull the cable out of the mount w to move the
9. Reinstall the drain plug and torque to specification.
upper jam nut t.
10. Add the recommended amount of fluid through the fill
hole. Maintain the fluid level even with the bottom
threads of the fill plug hole.
FLUID CAPACITY
Recommended Front Gearcase Fluid:
Demand Drive Fluid 2877922 (quart)
Capacity: approx. 8.5 oz (250 mL)

11. Reinstall the fill plug and torque to specification.
TORQUE

Front Gearcase Fill / Drain Plug Torque:
10 ft-lbs (14 Nm)
4. Adjust the shift cable so there is the same amount of
12. Check for leaks. Dispose of used fluid properly. cable travel when shifting slightly past HIGH gear
and PARK.
SHIFT CABLE INSPECTION / ADJUSTMENT 5. Thread the upper or lower jam nut as required to
Shift cable adjustment may be necessary if symptoms obtain proper cable adjustment.
include:
NOTE
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration This procedure may require a few attempts to obtain
• Inability to engage into a gear the proper adjustment.
• Excessive gear lash (noise)
• Gear selector moving out of desired range 6. Once the proper adjustment is obtained, place the
shift cable and upper jam nut into the mount. Tighten
1. Locate the shift cable q attached to the transmission
case in the right rear wheel well area. the lower jam nut against the mount.
7. Start engine and shift through all gears to ensure the
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 2.29
© Copyright Polaris Industries Inc.