Page 107 - Manual Oficina Polaris RZR XP 1000 17-18

MAINTENANCE

SPARK PLUG SERVICE 5. Remove spark plugs using a 5/8” spark plug socket
Inspect and replace the spark plugs at the intervals with an extension.
outlined in the Period Maintenance Chart. 6. Inspect electrodes for wear and carbon buildup. Look
for a sharp outer edge with no rounding or erosion of
1. Remove the cargo box access panel q.
the electrodes.
2

WARNING
7. Clean with electrical contact cleaner or a glass bead
A hot engine can cause serious burns. Allow engine to spark plug cleaner only.
cool or wear protective gloves when removing the spark
plugs. CAUTION
A wire brush or coated abrasive should not be used.
2. Remove both spark plug caps w.
8. Measure gap with a wire gauge. Adjust gap if
necessary by carefully bending the side electrode.
9. If necessary, replace spark plug with proper type.
CAUTION
Severe engine damage may occur if the incorrect spark
plug is used.

Recommended Spark Plug:
NGK MR7F / 0.7-0.8 mm

10.Install spark plugs and torque to specification.
TORQUE
NOTE
Spark Plug Torque:
Note MAG and PTO reference decals on spark plug 7 ft-lbs (10 Nm)
wires for reassembly.
11. Install the plug caps to the appropriate cylinder by
3. Clean out plug wells with compressed air to remove referencing the MAG and PTO spark plug wire
any loose dirt or debris. decals. Ensure wires are pushed down all the way so
they engage onto the spark plugs.
4. Rinse plug wells with water and dry with compressed
air. 12.Reinstall the cargo box access panel.
NOTE
Spark plug wells have drain holes built into the cylinder
head to allow water to drain out.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 2.61
© Copyright Polaris Industries Inc.