Page 269 - Manual Oficina Polaris RZR XP 1000 17-18

PVT SYSTEM

PVT DISASSEMBLY 9. Mark the drive belt direction of rotation and remove
drive belt (see Chapter 5 – Belt Removalpage 5.13).
1. Place transmission in neutral.
10.Remove the driven clutch retaining bolt and driven
2. Safely raise and support the vehicle. clutch.

CAUTION
WARNING
Do not strike the driven clutch to free it from the
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service transmission input shaft. This will damage the clutch.
procedure.
NOTE
3. Remove the left rear wheel. For MY16 models, if the driven clutch will not
4. Remove the lower mounting bolt and nut q from the disengage, a commercially found 2–Jaw puller may be
left rear shock. Discard the nut. used. Only pull from inside the slider pockets. Pulling
on the sheaves may cause damage to the clutch.
5. Swing shock outward toward the front of the vehicle.

6. Loosen the hose clamp attaching PVT intake hose to
the outer clutch cover and disengage the hose from
the outer clutch cover.
5
7. Remove the eight clutch cover screws w and remove
the outer clutch cover from the vehicle.

11. Install the Drive Clutch Holding Tool on the drive
clutch.

8. Loosen the hose clamps e attaching PVT inlet and
outlet ducts to the clutch cover. Disengage the hoses
from the clutch cover and remove the outer cover
from the vehicle.

Drive Clutch Holding Tool:
9314177-A

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 5.9
© Copyright Polaris Industries Inc.