Page 271 - Manual Oficina Polaris RZR XP 1000 17-18

PVT SYSTEM

PVT ASSEMBLY 6. Install the protective cover and the four push rivets
that secure the cover to the top of the inner PVT
1. Inspect inner clutch cover. Replace if cracked or cover.
damaged.
2. Inspect the seal on the transmission input shaft.
Replace if damaged.
3. Inspect inner clutch cover seal q (engine side).
Replace if cracked, torn or damaged.

7. Install the three inner clutch cover bolts and washers
that retain the cover to the engine and the four inner 5
clutch cover bolts and washers that retain the cover
to the transmission. Torque bolts to specification.
TORQUE
4. Apply silicone around all seven screw holes on the Inner Clutch Cover Bolts:
inner clutch cover. 12 ft-lb (16 Nm)

IMPORTANT
DO NOT apply silicone on drive and driven shaft 8. Clean the end of the taper on the crankshaft and the
inner cover donuts. tapered bore inside the drive clutch.
9. Install the drive clutch onto the engine.
5. Install and properly align the inner clutch cover. Be 10.Install the Drive Clutch Holding Tool (9314177-A) and
sure the fuel line, vent line and battery cables are torque the retaining bolt to specification.
properly routed through the guard plate as shown w.

TORQUE
Drive Clutch Retaining Bolt:
96 ft-lb (130 Nm)

11. Clean the splines inside the driven clutch and on the
transmission input shaft.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 5.11
© Copyright Polaris Industries Inc.