Page 300 - Manual Oficina Polaris RZR XP 1000 17-18

TRANSMISSION

TRANSMISSION SERVICE

TRANSMISSION REMOVAL 10. Remove the outer clutch cover, drive belt, drive
clutch, driven clutch, inner clutch cover and clutch
CAUTION outlet duct (see Chapter 5 – PVT Disassembly
(2014–2015)page ).
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this NOTE
procedure. Always wear eye protection.
Be sure to use the correct Drive Clutch Puller (PN
2872085) to prevent damage to crankshaft.
1. Remove the seats, console cover and engine service
panel (see Chapter 10 ).
2. Disconnect the (-) negative battery cable from the CAUTION
battery.
Correct Drive Clutch Puller P/N 2872085
3. Remove the rear bumper and cargo box as an
assembly (see Chapter 10 – Cargo Box Assembly
Removalpage 10.23).
4. Remove the air box assembly (see Chapter 4 – ETC
Replacementpage 4.42).
5. Raise and support the vehicle.
6. Remove the prop shaft from the transmission output
shaft (see Chapter 7 – Rear Prop Shaft
Removalpage 7.22).

11. Loosely install the left rear shock bolt to hold left rear
trailing arm up in position.
12. Remove the stabilizer bar mounting bolt and nut q
from both sides. Discard nuts and replace with new
upon assembly.

7. Remove rear wheels from the vehicle.
8. If internal transmission repair is required, drain the
transmission lubricant (see Chapter 2 –
Transmission Lubricationpage 2.49).
9. Remove the lower mounting bolt from the left rear
shock. Swing shock outward.

6.8 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.