Page 305 - Manual Oficina Polaris RZR XP 1000 17-18

TRANSMISSION

10.Torque left side mounting bolts to specification in 14.Install and properly route the gear position switch
sequence. connector t, speed sensor connector y, crankshaft
position sensor connector u, shift bracket and shift
bracket bolts i, shift cable clevis pin and washer o
onto the transmission.

11. Torque right side mounting bolts to specification using
the numbered sequence shown.

15.Torque the two shift cable bracket bolts to
specification.

TORQUE
6
Shift Cable Bracket Bolts:
17 ft-lb (23 Nm)

16.Install three wire ties to retain wire harness to
transmission and mounts.

TORQUE
Engine / Transmission Mounting Bolts:
Step 1-2: 64 ft-lb (87 Nm) Step 3: 5 ft-lb (7 Nm) Step
4-7: 44 ft-lb (60 Nm)

12.Remove the clutch center distance tool.
13.Remove the spacer or support between the vehicle
frame and engine.
17.Install and properly route the vent hose.
18.Lubricate the transmission splines and mid prop shaft
joint splines with Polaris All Purpose Grease. Install
the prop shaft onto the transmission output shaft (see
Chapter 7 – Rear Prop Shaft Installationpage 7.26).

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 6.13
© Copyright Polaris Industries Inc.