Page 337 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

DRIVE SHAFT

FRONT DRIVE SHAFT REMOVAL 6. Remove and discard the upper and lower ball joint
pinch bolts r and nuts.
1. Elevate front of vehicle and safely support machine
under the frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.

2. Remove the four wheel nuts and remove the front
wheel.
3. Remove the cotter pin q and loosen the front wheel
hub castle nut w. Remove the nut, and cone
washers e from the front wheel hub assembly.

7. Using a soft faced hammer, lightly tap on the bearing
carrier while removing the upper ball joint end.
8. Remove the drive shaft from the front bearing carrier.

7

4. Remove and discard the two front brake caliper
mounting bolts and remove the caliper from the
brake disc (see Chapter 9 – Caliper Removal page
9.18).
CAUTION 9. With a short, sharp jerk, remove drive shaft from the
Do not hang the caliper by the brake line. Use wire to front gearcase.
hang caliper to prevent damage to the brake line.

5. Remove the front wheel hub assembly.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 7.11
© Copyright Polaris Industries Inc.