Page 350 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

SUPPORT BEARING REPLACEMENT 6. Using an appropriate bearing/bushing installation
1. Remove the rear prop shaft from the vehicle (see sleeve, drive the support bearing assembly onto the
Chapter 7 – Rear Prop Shaft Removalpage 7.22). prop shaft until it seats against the shoulder on the
shaft.
2. Using a rubber mallet, remove the rubber isolated
bearing support from the shaft to expose the bearing.

NOTE
3. Using a commercially available 2-jaw puller, remove Only drive on the inner race of the bearing. Driving on
the bearing from the end of the prop shaft. the bearing in any other location will damage the
bearing.
4. Clean the bearing mounting surface on the shaft and
apply Loctite ® 603 ™ retaining compound to the
clean surface. 7. Wipe the bearing and shaft clean of any excess
retaining compound.
NOTE
Do not allow any Loctite to get in the bearing.
®
8. Install the rear prop shaft into the vehicle (see
Chapter 7 – Rear Prop Shaft Installationpage 7.26).

5. Install the new support bearing assembly onto the
end of the prop shaft.

7.24 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.