Page 414 - Manual Oficina Polaris RZR XP 1000 17-18

BRAKE SYSTEM

MASTER CYLINDER

MASTER CYLINDER REMOVAL 3. Place a container to catch brake fluid under the
master cylinder brake line banjo bolts r.
1. Locate the master cylinder q above the left front tire
in the wheel well area.
CAUTION
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.

NOTICE
Make note of front and rear brake line locations to
master cylinder.
4. Loosen the brake line banjo bolts and allow fluid to
drain.
NOTICE
Dispose of fluid properly. Do not re-use.

2. Remove the clip w from the clevis pin e that 5. Remove the two mounting fasteners t that secure
attaches the master cylinder to the brake pedal lever. the master cylinder to the frame.

MASTER CYLINDER INSTALLATION
1. Install new stat-o-seal, rear brake line banjo fitting,
new stat-o-seal and banjo bolt to the rear port on the
master cylinder.

IMPORTANT
Lubricate seals with a thin film of DOT 4 brake fluid
prior to installation.

9.10 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.