Page 416 - Manual Oficina Polaris RZR XP 1000 17-18

BRAKE SYSTEM

BRAKE BLEEDING / FLUID CHANGE 3. Add brake fluid to the indicated MAX level of
reservoir.
IMPORTANT
Bleed the right rear caliper first, followed by the left rear,
front right, and finally the front left caliper.

CAUTION
Always wear safety glasses when handling chemicals
and fluids.

CAUTION
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.
1. Clean master cylinder reservoir cover thoroughly and
remove the cover w. Polaris DOT 4 Brake Fluid
2872189

4. Bleed the brakes in the following order: right rear, left
rear, right front and finally the left front. Install a box
end wrench on caliper bleeder screw. Attach a clean,
clear hose to fitting and place the other end in a
clean container. Be sure the hose fits tightly on
fitting.
5. Have an assistant slowly pump foot pedal until
pressure builds and holds.
6. Hold brake pedal down to maintain pedal pressure,
and open bleeder screw e one full turn. Close
bleeder screw and release pedal.

2. If changing fluid, remove old fluid from reservoir q
with a Mity Vac™ pump or similar tool.
Mity Vac™:
2870975

NOTICE
Do not release foot pedal before bleeder screw is tight
or air may be drawn into master cylinder.

9.12 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.