Page 419 - Manual Oficina Polaris RZR XP 1000 17-18

BRAKE SYSTEM

FRONT BRAKES

PAD REMOVAL 6. Push the mounting bracket inward and slip the outer
brake pad out between the bracket and caliper body.
1. Elevate and support front of vehicle.
CAUTION
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.

2. Remove the wheel nuts and front wheel.
3. Loosen the pad adjuster screw 2-3 turns.

7. Remove the inner pad from the bracket and caliper.

PAD INSPECTION
1. Measure the thickness of the pad material. Replace
pads if worn beyond the service limit.

4. Remove the upper and lower caliper mounting bolts
and remove the caliper from the front hub.

NOTE
When removing caliper, use care not to damage brake
line. Support caliper to avoid kinking or bending brake
line.

5. Push caliper piston into caliper bore slowly using a
C-clamp or locking pliers with pads installed.
9

MEASUREMENT
Front Brake Pad Thickness:
.297 ± .007" (7.5 ± .178 mm)
Service Limit: 0.180" (4.6 mm)

NOTE
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 9.15
© Copyright Polaris Industries Inc.