Page 512 - Manual Oficina Polaris RZR XP 1000 17-18
P. 512

ELECTRICAL


                TEST 1: Resistance Value of Each Stator Leg          8. Example: The alternator current output reading
                1. Measure the resistance value of each of the three     should be approximately 21 VAC at 1300 RPM
                   stator legs: Y1 to Y2, Y1 to Y3, and Y2 to Y3. Each   between each ‘leg’.
                   test should measure: 0.07 - 0.13 Ω
                                                                                          NOTICE
                                       CONNECT         OHMS           If one or more of the stator leg output AC voltage varies
                    TEST                METER         READING           significantly from the specified value, the stator may
                                       LEADS TO:                                     need to be replaced.
                    Battery Charge      Y1 to Y2     0.07 - 0.13 Ω
                    Coil
                                                                                                  AC VOLTAGE (VAC)
                                                                             RPM READING
                    Battery Charge                                                                     READING
                    Coil                Y1 to Y3     0.07 - 0.13 Ω
                                                                                  1300               21 VAC ± 25%
                    Battery Charge
                    Coil                Y2 to Y3     0.07 - 0.13 Ω                3000               47 VAC ± 25%
                                                                                  5000               79 VAC ± 25%
                                     NOTICE
                  If there are any significant variations in ohm readings  STATOR (ALTERNATOR) REPLACEMENT
                 between the three legs it is an indication that one of the
                          stator legs may be weak or failed.         Refer to Chapter 3 – Stator Cover Removal /
                                                                     Inspectionpage 3.43 procedure to service the stator.
                   TEST 2: Resistance Value of Each Stator Leg to                         NOTICE
                   Ground
                                                                         The stator cover can be removed with the engine
                2. Measure the resistance value of each of the stator               installed in the chassis.
                   legs to ground: Y1 to Ground, Y2 to Ground, Y3 to
                   Ground.                                             Be sure to thoroughly clean the area around the stator
                                                                                     cover prior to removal.
                3. Each test should measure: Open Line (OL)

                                      CONNECT       OHMS
                    TEST              METER         READING
                                      LEADS TO:
                    Battery Charge    Y1, Y2, or Y3  Open Line
                    Coil              to Ground     (Infinity)


                                     NOTICE
                Any measurement other than Infinity (open) will indicate
                            a failed or shorted stator leg.


                   TEST 3: Measure AC Voltage Output of Each
                   Stator Leg at Charging RPM
                4. Set the selector dial to measure AC Voltage.
                5. Start the engine and let it idle.
                6. While holding the engine at a specified RPM,
                   separately measure the voltage across each ‘leg’ of
                   the stator by connecting the meter leads to the wires
                   leading from the alternator (Y1 to Y2, Y1 to Y3, Y2 to
                   Y3).
                7. Refer to the following table for approximate AC
                   Voltage readings according to RPM. Test each leg at
                   the specified RPM in the table.








                11.44                                                  9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
                                                                                                © Copyright Polaris Industries Inc.
   507   508   509   510   511   512   513   514   515   516   517