Page 249 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

16.Measure the installed height of the new mechanical 20.Install the oil dipstick.
seal as shown below. If not within specification, 21.Install the coolant hose to the water pump cover and
remove and discard the mechanical seal and properly tighten hose clamp.
install new mechanical seal as outlined in this
chapter. 22.Connect the stator wire connector and securing the
wiring to the front engine mount bracket.
23.Install the CPS sensor into the stator cover. Inspect
CPS O-ring and replace if needed.
24.Install the seat, right side panel and footwell.
25.Connect the (-) negative battery cable.
3
26.If the engine oil was contaminated during this service
procedure, perform an engine oil change as outlined
in Chapter 2. DO NOT run the engine until coolant
has been added to the cooling system.
27.Fill cooling system with recommend coolant and
bleed the system of air as outlined in this chapter.
28.Check for leaks.

MEASUREMENT
Mechanical Water Pump Seal Installed Height:
0.280” - 0.287” (7.2 +/- 0.1 mm)

17.Install the water pump impeller r.

NOTE
The water pump impeller r uses reverse (LH) threads.
Finger tighten only.

18.Install a new water pump cover gasket.
19.Install the water pump cover to the stator cover.
Torque all fasteners in sequence to specification.

TORQUE
Water Pump Cover Fastener:
9 ft-lbs (12 Nm)Torque in Sequence

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 3.127
© Copyright Polaris Industries Inc.