Page 253 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

11. Disconnect the IAC valve e, TPS r, T-MAP sensor 15. Place a shop to beneath the fuel line quick connector
t, harness leads from the throttle body. to catch any excess fuel. Disconnect the fuel line (8)
from the fuel rail by pressing in on the quick
NOTE connector tabs.
Vehicles equipped with ETC do not use an IAC e or 16. Move fuel line to the left-hand side of the engine
TPS sensorr. Disconnect the ETC assembly form the compartment. Make note of line routing for
wiring harness at this time. installation.
17. Disconnect the ignition coil harness connector and
remove the spark plug wire from the engine.
18. Disconnect the stator wire connector and cut the tie 3
strap securing the wiring to the left front engine
mount bracket. Replace tie strap for engine
installation. (note routing for reassembly)

19. Disconnect the CPS sensor from the vehicle wiring
harness and remove the strain relief.(note routing for
reassembly)

12. Loosen the hose clamp y securing the throttle body
to the engine intake boot. Remove throttle body from
the engine and wrap it with a clean shop towel. Place
throttle body on the left-hand side frame rail area.

NOTE
Remove the fasteners used to mount the ETC
assembly to the intake on vehicles equipped with ETC.

NOTE
Image for reference only

20. Remove (+) positive cable from the starter motor.
1. If desired, remove the remaining starter motor
bolt and remove the starter motor from the
engine.
21. Remove (-) negative cableq by removing the starter
mounting bolt.

NOTE
Be sure dirt and debris do not enter the engine, air box
or throttle body. Use clean shop towels to plug engine
and air box intake holes.

13. Disconnect the fuel injector harness lead u from the
fuel injector.
14. Properly relieve fuel pressure from the fuel rail.

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 3.131
© Copyright Polaris Industries Inc.