Page 248 - Manual Oficina Polaris Sportsman 570 2014 a 2016
P. 248
ENGINE / COOLING SYSTEM
10.Align the water pump drive slot as shown below. 13.If needed, install the stator cover removal handles
tool to the water cover bolt holes to aid in stator cover
installation.
State Cover Removal Handle: PA-49317
14.While installing the stator cover to the engine, slightly
rotate the water pump impeller to verify the crankshaft
slot and the water pump drive shaft blade are
properly engaged. Verify the stator cover is laying flat
on the engine case.
CAUTION
The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal and installation process or
injury could result.
IMPORTANT
The crank shaft and water pump drive shaft must me CAUTION
aligned for the case to be assembled.
If the water pump drive shaft blade and slot in the crank
shaft are not in alignment during the installation
process, severe engine damage may result.
15.Install and torque the stator cover fasteners in
sequence to specification. (See Torque Sequence,
page 3.98)
TORQUE
Stator Cover:
9 ft-lbs (12 Nm)Torque in Sequence
11. Align the water pump drive shaft blade as shown
below.
12.Apply a small amount of crankcase sealant to the
area indicated below q.
3.126 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.
