Page 505 - Manual Oficina Polaris Sportsman 570 2014 a 2016

FINAL DRIVE

HUBS 3. Inspect the bearing.

FRONT HUB NOTE
Due to extremely close tolerances and minimal wear,
DISASSEMBLY the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
NOTE spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
Follow steps 1-10 for wheel/hub removal in ‘Front Drive down movement and minimal movement sideways
Shaft (CV) Service / Removal’ between inner and outer race.

1. Remove outer snap ring. 4. Inspect bearing housing for scratches, wear or
damage. Replace housing if damaged.

ASSEMBLY
1. Support bottom of hub strut housing.
2. Start bearing in housing.
3. Press bearing into place until outer race bottoms on
housing.
CAUTION
When using an arbor press be sure to press only on the
outer race to avoid bearing damage.
2. From the back side, tap on the outer bearing race 4. Install snap ring into groove.
with a drift punch in the reliefs as shown.
NOTE 7
Follow steps 2-6 for wheel/hub installation in ‘Front
Drive Shaft (CV) Service / Installation’

NOTE
Drive bearing out evenly by tapping on outer race only.
Once bearing is at bottom of casting, support casting on
outer edges so bearing can be removed.

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 7.29
© Copyright Polaris Industries Inc.