Page 582 - Manual Oficina Polaris Sportsman 570 2014 a 2016

BRAKE SYSTEM

4. Slowly pump the brake lever until pressure has been 3. Remove caliper mounting bolts and lift caliper off of
built up. Maintain at least 1/2, (12.7 mm) of brake disc.
fluid in the reservoir to prevent air from entering the
brake system.
5. Install the adjuster screw and turn clockwise until the
stationary pad contacts the disc, then back off 1/2
turn (counterclockwise).

NOTE
When removing caliper, be careful not to damage brake
line. Support caliper so as not to kink or bend brake
line.

4. Push caliper pistons into caliper bore slowly with
pads installed.
6. Verify fluid level in reservoir is up to the MAX line
inside reservoir and install reservoir cap.
7. Install wheel(s) and torque wheel nut(s).
8. It is recommended that a burnishing procedure be
performed after installation of new brake pads to
extend service life and reduce noise.

REAR PAD REMOVAL
1. Support the machine. Remove the rear tire.
2. Loosen the slide pins with a hex wrench.

5. Remove the caliper slide pins and remove the brake
pads from the caliper.

6. Clean the caliper with brake cleaner or alcohol.

9.24 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.