Page 708 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ELECTRICAL

2. Loosen the fastener located on the outside of the 3. Drill a .55” (14mm) hole in the center of the boss as
headlight. indicated below to access the upper mounting /
adjustment screw.

3. Tilt the headlight upward or downward.
4. Tighten the screw until fully seated.

LOWER HEADLIGHT ADJUSTMENT 4. Adjust the beam to the desired position by loosening
(FOREST) or tightening the (3) T-25 adjustment / mounting
screws.
NOTE 5. Once the adjustment is completed, plug the .55”
(14mm) access hole with a compartment plug (PN
The following procedure may be needed on some 5412981).
international units.
6. Repeat procedure to adjust the other lower
1. The bottom two headlight mounting screws / headlight.
adjusters (A) can be access directly through the
fender openings. HEADLIGHT SWITCH TEST
2. The single upper headlight mounting screw / adjuster 1. Remove the headlight pod cover.
(B) is only accessible after a .55” (14mm) hole is 2. Set meter to DC Volts and probe the headlight plug
drilled into the front cab.
wires (Brown and Yellow) at back of connector for 12
Volts.
3. Turn ignition and headlight on. If there is no power,
continue with checks to the harness and fuses.

11.46 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.