Page 709 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ELECTRICAL

BRAKE LIGHT REPLACEMENT BRAKE LIGHT SWITCH
The brake light (A) is located in the rear tail lamp 1. Disconnect battery.
housing.
2. Remove the front rack.
3. Remove the front cover.
The brake pressure switch is located below the ecu.
The vehicle wiring harness will need to be pushed to
the side to gain access.

1. To remove the brake light electrical connector (A) ,
press in on the tab on the connector to unlock the
connector and pull the connector from the bulb
assembly.

4. Disconnect wire harness from switch.
5. Connect an ohmmeter across switch contacts.
Reading should be infinite (OL).
6. Apply brake at handlebar lever and check for
continuity between switch contacts. Replace switch if
there is no continuity or greater than .5 ohms
resistance when the brake is applied with slight
pressure.

2. To replace either of the bulbs, turn the holder
assembly counter-clockwise to remove and pull out.
Turn the holder assembly clockwise to install. Refer
to the parts manual for the correct bulb part number.

11

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 11.47
© Copyright Polaris Industries Inc.