Page 317 - Manual Oficina Polaris RS1 2018 e 2019

FINAL DRIVE

FRONT DRIVE SHAFT INSTALLATION 5. Install new pinch bolts and nuts e. Torque to
1. Install new spring ring q on drive shaft. Apply an specification.
anti-seize compound to the splines w.

TORQUE
2. Align splines of drive shaft with front gearcase and
reinstall the drive shaft. Use a rubber mallet to tap on Ball Joint Pinch Bolts:
the outboard end of the drive shaft if necessary 42 ft-lbs (57 Nm)

6. Apply Anti-Seize to drive shaft axle splines.
7. Install front wheel hub assembly r, cone washer(s)
t, and hand tighten the castle nut. Install washers
with domed side out.

7

3. Install drive shaft into the front bearing carrier.

4. Install the upper and lower ball joint ends into the
front bearing carrier.

9928689 - 2018 RZR RS1 Service Manual 7.11
© Copyright Polaris Industries Inc.