Page 319 - Manual Oficina Polaris RS1 2018 e 2019

FINAL DRIVE

8. Remove lower shock mounting bolt and nut y. Swing REAR DRIVE SHAFT INSTALLATION
shock inward. Discard the nut.
9. Remove the stabilizer bar mounting bolt, washer, and 1. Install new spring ring q on drive shaft. Apply an
nut u. Discard the nut. anti-seize compound to the splines w.
10.Lift trailing arm assembly upward so the rear drive
shaft is parallel with the ground.
11. Leaving the drive shaft in the transmission, swing the
rear trailing arm assembly outward until it is free from
the rear drive shaft.
12.Lower the trailing arm.

2. Align splines of drive shaft with transmission splines
and reinstall the drive shaft. Use a rubber mallet to
tap on the outboard end of the drive shaft, if
necessary.

13.With a short, sharp jerk, remove drive shaft from the
transmission splines.

7

3. Swing rear trailing arm assembly outward and
upward until rear axle can be inserted into the bearing
carrier. Support trailing arm from underneath.

4. Install the lower shock mounting bolt and new nut.
Torque fastener to specification.

9928689 - 2018 RZR RS1 Service Manual 7.13
© Copyright Polaris Industries Inc.