Page 328 - Manual Oficina Polaris RS1 2018 e 2019

FINAL DRIVE

22.Pull rear prop shaft out from under the vehicle. PROP SHAFT INSTALLATION
1. Reverse “Prop Shaft Removal” procedure to reinstall
the prop shafts.
2. Lubricate front gearcase shaft splines with Anti-Seize.
3. Lubricate the front and rear prop shaft mid joint with
Polaris All Purpose Grease.
4. Align the front and rear prop shafts as shown below
and slide them together.

NOTE
Paint marks are applied to the front and rear prop shafts
to aid shaft alignment. Reference these marks during
installation if still visible.
5. When installing the front prop shaft onto the front
gearcase, use a new roll pin.
6. Torque rear prop shaft to transmission fasteners to
specification.

TORQUE
Rear Prop Shaft to Transmission Fastener:
22 ft-lbs 30 Nm)

7. Torque prop shaft hoop fasteners to specification.

7.22 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.