Page 333 - Manual Oficina Polaris RS1 2018 e 2019
P. 333
FINAL DRIVE
AWD DIAGNOSIS 4. Inspect armature plate e for a consistent wear
Symptom: AWD Will Not Engage pattern. There should be two distinct wear bands r.
If only one band of wear is present (or if there is wear
1. Check the gearcase coil resistance. To test the coil between the two bands), inspect the coil area as
resistance, measure between the ground wire q indicated in Step 5. A wear band with an interrupted
(GY) and power wire w (BN/WH). Measurement wear mark may indicate a warped plate, which may
should be within specification. cause intermittent operation.
Front Gearcase Coil Resistance:
21 - 27 Ω
2. Turn on ignition and AWD switches and place gear
selector in High or Low. Check for minimum battery
voltage at Gray and Brown/White chassis wires that
power the coil. Should have a minimum of 11 VDC. 5. Check to make sure the coil t is seated in the U- 7
3. If electrical tests are within specification, remove shaped insert y that is pressed into the gearcase
gearcase (see “Front Gearcase Removal” outlined in cover u. The top of the coil should be seated below
this chapter) and inspect components. the U-shaped insert. The U-shaped insert controls the
pole gap. If the top of the coil is above the surface of
the U-shaped insert it raises the armature plate,
thereby increasing pole gap. If the pole gap increases
the coil will not be strong enough to engage the AWD
system. If this is found, replace the cover plate
assembly.
9928689 - 2018 RZR RS1 Service Manual 7.27
© Copyright Polaris Industries Inc.
