Page 471 - Manual Oficina Polaris RS1 2018 e 2019
P. 471
ELECTRICAL
ALL WHEEL DRIVE COIL DIAGNOSING SYSTEM FAILURES
OPERATION OVERVIEW • Verify the AWD switch is functional and that a
minimum of 11 volts is present at the hub coil.
• When the key switch is “ON”, 12 VDC power is present • Verify the AWD hub coil is functional. Test the AWD
at the hub coil. hub coil using an ohm meter. See specifications below:
• When the AWD switch is “ON”, and if the criteria is
met, the Engine Controller provides a ground path
(brown/white wire). When this occurs the AWD icon
should display in the instrument cluster.
• The AWD system must be grounded to operate.
AWD Hub Coil Resistance:
24 Ω ± 5%
• Verify the wiring harness, wiring, connectors,
connector pins and grounds are undamaged, clean
and connect properly.
• Verify continuity of wire connections with a known
good volt/ohm meter.
NOTE
Verify all wires and wiring connections have been
tested properly with a known good volt/ohm meter
before suspecting a component failure. 80% of all
electrical issues are caused by bad/failed connections
and grounds.
11
9928689 - 2018 RZR RS1 Service Manual 11.23
© Copyright Polaris Industries Inc.
