Page 119 - Manual Oficina Polaris RZR 570 13-18
P. 119

ENGINE / COOLING SYSTEM

                   THERMOSTAT REPLACEMENT                                WATER PUMP COVER AND IMPELLER
                   1. Remove the hood from the front cab.                SERVICE

                                        WARNING                                                NOTE
                       The cooling system is under pressure and serious     The water pump cover, gasket and impeller can be
                       burns may result. Allow the engine to cool before   serviced with the stator cover installed on the engine.
                                        servicing.
                                                                         1. Allow engine and cooling system to completely cool.
                   2. Remove the pressure cap to relieve any system
                       pressure (see Chapter 3 – Pressure Cap Test, page                     CAUTION
                       3.19).                                             Be sure the engine has cooled and no pressure is built  3
                   3. Drain coolant to a level below the thermostat       up in the cooling system before removing the pressure
                       housing.                                            cap. The coolant may be hot and could cause severe
                                                                                           injury or burns.
                   4. Remove the cargo box access panel.

                   5. Remove the spark plug wire from the engine.        2. Remove both seats and the engine service panel.
                   6. Remove the two bolts q retaining the thermostat    3. Disconnect the (-) negative battery cable.
                       cover.
                                                                         4. Remove all debris and thoroughly clean water pump
                                                                             area and right-hand side of engine block.
                                                                         5. Remove the hood.
                                                                         6. Remove the pressure cap from the filler neck.
                                                                         7. Completely drain cooling system and engine as
                                                                             outlined in this chapter.
                                                                         8. Raise and safely support the vehicle. Remove the
                                                                             right-hand rear wheel.
                                                                         9. Remove the eight bolts q attaching the water pump
                                                                             cover to the stator cover.




                   7. Lift the cover from the engine and remove the
                       thermostat.

                   8. Reverse this procedure for installation. Replace
                       thermostat seal if worn or damaged. Torque
                       thermostat cover bolts to specification.

                                       TORQUE
                                  Thermostat Cover Bolts:
                                     7 ft-lbs (10 Nm)

                   9. Be sure to properly fill and bleed cooling system as
                       outlined in this chapter.                         10. Remove the water pump cover w and water pump
                                                                             cover gasket e. Discard the water pump gasket .
                                                                         11. Using an 8mm socket, remove the water pump
                                                                             impeller r.
                                                                                               NOTE
                                                                           The water pump impeller uses reverse (LH) threads.

                                                                         12. Inspect the water pump cover and impeller for
                                                                             damage. Replace as necessary.




                   9926813 R06 - 2013-2016 RZR 570 Service Manual                                                     3.21
                   © Copyright Polaris Industries Inc.
   114   115   116   117   118   119   120   121   122   123   124