Page 120 - Manual Oficina Polaris RZR 570 13-18

ENGINE / COOLING SYSTEM

13. Follow this procedure in reverse to assemble the WATER PUMP MECHANICAL SEAL / OIL
water pump impeller and cover. Always use a new SEAL REPLACEMENT
water pump cover gasket. Torque all fasteners in
sequence to specification. NOTE
The stator cover must be removed from the engine to
service the water pump drive shaft, oil seal, mechanical
seal and bearing.

1. Allow engine and cooling system to completely cool.
CAUTION

Be sure the engine has cooled and no pressure is built
up in the cooling system before removing the pressure
cap. The coolant may be hot and could cause severe
injury or burns.

2. Remove both seats and the engine service panel.
3. Disconnect the (-) negative battery cable.
TORQUE 4. Remove all debris and thoroughly clean water pump
area and right-hand side of engine block.
Water Pump Cover Fastener:
9 ft-lb (12 Nm)(Apply Loctite® 204™ to bolt threads) 5. Remove the hood.
6. Remove the pressure cap from the filler neck.
14. Fill and bleed cooling system as outlined in this
chapter. 7. Completely drain cooling system and engine as
outlined in this chapter.
8. Raise and safely support the vehicle. Remove the
right-hand rear wheel.
9. Disconnect the stator wire connector and cut the tie
strap securing the wiring to the front engine mount
bracket.

3.22 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.