Page 240 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM
PVT DISASSEMBLY
CAUTION
Correct Drive Clutch Puller P/N PA-48595
Using the incorrect clutch puller may cause damage to
the end of the crankshaft.
1. Remove the seats and engine service panel (see
chapter 10 – ).
2. Disconnect the (-) negative battery terminal.
3. Place transmission in neutral.
4. Raise and support the vehicle.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure.
5. Remove the left rear wheel.
6. Remove the eight clutch cover screws q and
remove the outer clutch cover from the vehicle.
5.8
7. Mark the drive belt direction of rotation and remove
drive belt (see Chapter 6 – Belt Removal, page 5.11).
CAUTION
Non-EBS Models ONLY: RZR 570 Base and S models
use a B.O.S.S (Built on Secondary Shaft) driven clutch.
Inner and outer clutch sheaves will come off separately.
Hold outer sheave securely when removing the
retaining bolt to relieve spring pressure while
removing the retaining bolt.
8. Non-EBS Models: Noting clutch sheave orientation,
remove the driven clutch retaining bolt, outer clutch
sheave, thrust washers and inner clutch sheave.
EBS Models: Remove the driven clutch retaining
bolt and driven clutch assembly.
9. Install the Drive Clutch Holder.
10. Remove the drive clutch retaining bolt w and
remove drive clutch using the Drive Clutch Puller.
Drive Clutch Puller: PA-48595
Drive Clutch Holder: 9314177
11. Loosen hose clamp e attaching the PVT inlet duct to
the inner clutch cover. Disengage hose from the
inner clutch cover.
9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.