Page 241 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

12. Loosen the hose clamp (A) that attach the clutch PVT ASSEMBLY
outlet duct to the inner clutch cover. Disengage the 1. Inspect inner clutch cover. Replace if cracked or
hose from the cover. damaged.

13. Remove the eight bolts r that retain the inner clutch 2. Inspect the seal on the transmission input shaft.
cover to the engine and transmission. Remove inner Replace if damaged.
clutch cover. Make note of cable and hose routing for
assembly. 3. Remove silicone sealant from the engine case and
inner PVTcover.
4. Apply RTV silicone sealant to the back side of the
inner clutch cover q to ensure a water tight fit
between the engine and inner clutch cover. Both
surfaces must be clean to ensure adhesion of the
silicone sealant.

5

5. Install and properly align the inner clutch cover. Be
sure the cable and hose routing is correct.
6. Install the four inner clutch cover bolts and washers
that retain the cover to the transmission and the four
inner clutch cover bolts and washers that retain the
cover to the engine. Torque bolts to specification.

TORQUE
PVT Inner Clutch Cover Bolts:
12 ft-lbs (16 Nm)

7. Clean the splines inside the driven clutch and on the
transmission input shaft.
8. Apply a light film of grease to the splines on the
shaft.
9. EBS Models: Install the driven clutch assembly,
washer and retaining bolt. Torque to specification.
Non-EBS Models: Install the inner clutch sheave,
thrust washers and, noting clutch sheave orientation,
outer clutch sheave. Torque retaining bolt to
specification.
TORQUE
Driven Clutch Retaining Bolt:
36 ft-lbs (49 Nm)

9926813 R06 - 2013-2016 RZR 570 Service Manual 5.9
© Copyright Polaris Industries Inc.