Page 244 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

BELT INSPECTION 6. Install the outer clutch cover and eight bolts. Torque
1. Inspect belt for hour glassing (extreme circular wear bolts to specification.
in at least one spot and on both sides of the belt). TORQUE
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt. PVT Outer Clutch Cover bolts:
100 in-lbs (12 Nm)
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary. PVT BREAK-IN (DRIVE BELT / CLUTCHES)
3. Belts with thin spots, burn marks, etc., should be A proper break-in of the clutches and drive belt will
replaced to eliminate noise, vibration, or erratic PVT ensure a longer life and better performance. Break in the
operation. See the Troubleshooting Chart at the end clutches and drive belt by operating at slower speeds
of this chapter for possible causes. during the 10 hour break-in period as recommended (see
BELT INSTALLATION Chapter 3 – Engine Break-In Period, page 3.37 for
break-in example). Pull only light loads. Avoid aggressive
NOTE acceleration and high speed operation during the break-
in period.
Be sure to install belt in the same direction as it was
removed.
CLUTCH CENTER DISTANCE
1. Non-EBS Models ONLY: Loosen the driven clutch
retaining bolt to help spread the clutch sheaves. INSPECTION
EBS Models ONLY: Insert the belt removal tool (PN 1. Remove the outer PVT cover, drive belt, drive clutch
2877408) into the driven clutch as shown and loop and driven clutch as outlined in this chapter.
the belt over the driven clutch sheave.
NOTE
The inner PVTcover does not need to be removed to
check the clutch center to center distance.

2. Rotate the tool towards the clutch to open the
sheaves.
3. Rotate the driven clutch and walk the belt into the
clutch.
4. Rotate / spin the driven clutch and belt approximately
5-7 times to properly seat the belt in the driven
clutch.

5. Non-EBS Models ONLY: Torque driven clutch
retaining bolt to specification.
TORQUE

Driven Clutch Retaining Bolt:
36 ft-lbs (49 Nm)

5.12 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.