Page 245 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

2. Install the Clutch Center Distance Tool onto the ADJUSTMENT
crankshaft and transmission input shaft. Use the 1. Remove the Clutch Center Distance tool from the
drive shaft mounting bolt q to properly hold the tool engine and transmission.
to the crankshaft. The tool should rest on the splines
of the transmission input shaft w. The pictures below 2. Remove the inner PVT Cover.
show the tool properly installed.
3. Loosen the eight engine to transmission coupler
bolts q.

5

Clutch Center Distance Tool:
PU-50658-A 4. Loosen the two fasteners w securing the rear
transmission isolator to the vehicle frame.
NOTE 5. With the engine and transmission mounting
fasteners loose, install the Clutch Center Distance
The Clutch Center Distance Tool is used for the center- Tool as shown, using the drive clutch mounting bolt
to-center distance only. Make sure that the tool is e to secure the tool to the crankshaft and align the
laterally aligned well with the machine and not binding tool on the splines of the transmission input shaft r.
on the shafts.

3. If the tool fits as shown above, the clutch center to
center distance is correct.
4. If the tool does not fit as shown above, adjustment is
needed.

Clutch Center Distance Tool:
PU-50658-A

9926813 R06 - 2013-2016 RZR 570 Service Manual 5.13
© Copyright Polaris Industries Inc.