Page 292 - Manual Oficina Polaris RZR 570 13-18

TRANSMISSION

6. Inspect the pinion shaft assembly. Replace bearings 9. Using a 5 mm Allen wrench, install only the three
if needed. Inspect each gear for damage, chips or screws that secure the pinion shaft assembly as
abnormally worn teeth. shown below. Leave the longer locking screw (A) out
at this point.

NOTE
NOTE DO NOT install the longer screw (A). Installing the
If pinion shaft was disassembled, the bearing cover longer screw will lock the snorkel tube and not allow for
must be installed on the shaft before installing the 46T backlash setting adjustment.
gear.
10. Torque the bearing cover retaining screws to
7. Install the pinion shaft assembly. Be sure to properly specification.
mesh the snorkel shaft bevel gear with the pinion
shaft bevel gear. TORQUE
8. Apply Loctite 242 ™ to the threads of the bearing Bearing Cover Retaining Screws:
®
cover retaining screws. 8 ft-lbs (11 Nm)
11. Rotate the snorkel tube counterclockwise using the
snorkel tool (PA-50231) until the snorkel gear and
pinion gear have ‘zero’ backlash.
NOTE

DO NOTovertighten the snorkel tube when backing it
out. At the 'zero' backlash position, you should still be
able to turn the snorkel shaft using your fingers, but it
will feel rough and may have some tight spots.

12. Look down into the transmission housing to see the
snorkel locking screw hole opening to reference your
starting point.

NOTE
If you have a hard time seeing into the hole, insert a
small Allen wrench, punch or screwdriver into the hole
to feel when the notch is aligned with the hole.

6.22 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.