Page 333 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

REAR BEARING CARRIER BUSHING REAR BEARING CARRIER INSTALLATION
REPLACEMENT 1. Install drive shaft axle through the backside of the
Check bearing carrier bushings q and pivot tubes w for bearing carrier. Be sure bushings and pivot tubes are
excessive wear or damage. If replacement is required, installed.
slide pivot tubes out and remove bushings with a drift 2. Install the fasteners t retaining the rear bearing
punch. Install new bushings by pressing them into the carrier to the upper and lower A-arms. Torque NEW
bearing carrier. nuts to specification.

TORQUE
Rear Bearing Carrier Fasteners:
40 ft-lb (54 Nm)

3. Apply grease to drive shaft axle splines.
7
4. Install rear wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.9
© Copyright Polaris Industries Inc.