Page 345 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

3. Safely raise and support vehicle. Remove the left- 7. Remove the gear selector cap and remove the
hand rear wheel. retaining screw w and handle.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.

4. From the right front wheel well, locate the prop shaft
roll pin q. Use the Roll Pin Removal Tool to remove
the roll pin from the front gearcase.

8. Remove the Torx screws e retaining the center
console to access the prop shaft.
9. Remove the T-27 Torx screws and the push pins
securing the driver’s side floor, left-hand rocker panel
and the left rear panel divider.
10. Gently lift and support floor and panel divider upward
in order to allow the prop shaft to pass beneath
them.
11. Slide prop shaft back far enough to remove it from
Roll Pin Removal Tool: the front gearcase input shaft splines.
2872608 12. Pull sharply forward to remove the prop shaft from 7
transmission shaft.
5. Remove the outer clutch cover, drive belt and drive
clutch. Refer to PVT Disassembly, page . 13. Position prop shaft to the right side of the front
gearcase as shown.
6. Remove the two screws q retaining the brake line
junction block and move the junction block towards
the outside of the vehicle.

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.21
© Copyright Polaris Industries Inc.